top of page
The TG/MN cuff can be used where a pressure-tight end is required and where axial and radial movements still need to be absorbed.
All sealing segments are embedded in secure sealing pockets and are thus optimally protected against slipping and cold flow behavior of the sealing material, thus ensuring the exact arrangement of the stainless steel tension bands.
Due to the flexibility of the material, no large distances between the media and the jacket tube are required, but a minimum ring gap of 40 mm is required.
1/2
The material fold absorbs the pipe movements and thus provides the necessary flexibility. The pressure tightness is achieved by pressing the stainless steel strips over the sealing segment.
​
Before filling, the cuff must be covered with a stretch pad
(placed on site).
bottom of page